How to do a whip finish in fly tying

Do you know how to do a whip finish in fly tying? What about the meaning of the term itself? As an angler, performing certain fly fishing techniques requires the knowledge of an expert or proper directions in order to arrive at a convincing set up that will impact positively on your activity.   

Some anglers learn about making a whip finish in their first days of training while others get to know it later. However, the majority of anglers prefer delegating such a take to experienced or properly trained people since they can't do it by themselves. It's good begin finishing a fly trying whip by using your hands before advancing on to the whipping tools. It's good to interact with various anglers who are more experienced for you to learn how to do a whip finish in fly tying




What is a whip finish in fly tying?. 

In simple terms, a whip finish is simply a noose or a slip knot which is usually placed at any part of the hook or right at the head of the fly where you intend to make the knot. To understand this better, it's a free threat that usually extends inwards to the bobbin. It's advisable to make a whip using several wraps of thread preferably 5 to strengthen the knot. When during the whip finish, always keep in mind the direction in which the wraps are going. For efficiency and effectiveness, let the wraps to go towards the hooks eye so that the thread formed can be covered fully by knots as the wrapping threads tighten. This prevents the possibility of the fish falling off during the catch in case the loop unties.  

Doing a whip finish in fly tying.  

Start by pulling more of the thread off the bobbin to prevent any interferences from the tool. To maintain the required tension, ensure that you pinch the thread using your index finger and the thumb. 

Do this by looping the thread onto your middle finger. 

Check to ensure that the shape which is formed is triangular and placed under or below the hook. Move the standing thread or the sliding thread up and close to the hook while you keep maintaining the threads tension because this is the section where the whip finish will be tied. 

Proceed and let go off the bobbin which was initial held by your left hand and hold the triangular part of the thread. Using the free left hand to wind the thread onto the hook as you pass it through to the right hand. Pause and then return the thread to the initial left hand while maintaining the wrap. The thread which is approaching hook from the fly should be kept in front of the fly hook since it's the one covered by wraps. Keep doing this and when not less than four wraps have been made.

 While maintaining the tension, insert a scissor or bodkin needle right at the centre of the loop. Pull the thread using either of the instruments and to make the whip finish tight. The device moves to the hook when you noose closes then remove the scissors and the bobbin from the noose when the device touches the hook. Clip the thread to complete your whip finish.


Prev: Fly Tying Tools And How To Use Them

Next: A different fishing experience in Boone nc for the anglers

Tags: how to do a whip finish in fly tying


Tracking Orders