Your shopping cart is empty!
how to tie a dropper knot fly fishing
The most important technique that will ensure you maximize on your catch is to know how to tie a dropper knot fly fishing. It's commonly known as the blood knot or dropper loop knot.
The majority of bottom fishermen often employ the use of this technique in attaching a tube lure or rubber worm just above the jig. Additionally, it's also used to make and provide a large surface for the attachment of multiple bait rigs which greatly helps in catching a number of fish in a single cast. Apparently, some bottom fishermen also use dropper knots for attaching second flies on the leaders. Blood knots are essential fishing instruments that can increase the amount of your catch regardless of whether you have a single fishing line or not.
In order to increase the amount of your catch, a copper can be tied in wide loops which will allow you to cut one side of the loop and leave it hanging to provide a surface for attachment of multiple hook baits.
However, most people find it hard to tie and fix blood knots on their fly lines and as a result, they tend to ignore such a tool which has numerous benefits. So if you fall in the category of those who have a negative perspective about how to tie a blood knot, then given below are the best guidelines that will help you to have an easy task while making a dropper knot.
Firstly, begin by choosing the desired location on which you are going to make your loop. This can be easily done by deciding on the number of droppers that you are going to make and then marking on the chosen points with a clear mark. Form the first loop at the desired location and then let the line pass through the loop from one side to the other. Keep in mind that, the line should pass specifically on the side where the loop is formed.
After this, produce several wraps preferably 5 and then keep the newly formed loop open. Using your hands, push the lower side of the original loop upwards between a new opening and use your teeth to hold it in place. Ideally, you can make the knot wet using your saliva to make it slippery before pulling both ends of the loop in opposite or simply different directions.
Make the loop to stand out by pulling the ends of the line uniformly to tighten the loop. In case you realize that the knot is still tight, lubricate the it once more and then fasten it.
Finally, thread the raised loop through the open hook to attach a hook or you can cut one side of the blood loop knot and then pass the hook through it. In case you want you to add lure beads, then start by sliding them towards the dropper before setting up the hook. Making multiple loops can be done easily just by following the above procedure by taking ample time.
How to Put a Leader on a Fly Fishing Line?
What Are the Various Fly Fishing Rod Price Range at the Stores?