How to Make Your Own Fly Fishing Leaders?

Do you love fly fishing? What should be in your fingertips when it comes to fly fishing? Well, fly fishing can often be confusing especially for beginners. You need to familiarize yourself with the language used in fly fishing, understand how the equipment used are made and how they work. In this piece, I'm going to help you understand how to make your own fly fishing leaders. Continue reading the article to find out! 


Leaders are basically used in fly fishing to make the fish see the fly and not the line that is attached and will eat the fly without any suspicion. One of the primary reasons why many fishermen don't catch fish is the myths that it is hard to cast a long and thin leader. But is that the case? Well, doing this is pretty simple if you understand your needs.

You'll probably catch no fish if you tie on a heavy and straight leader material that will bounce to the left and to the right. Then at the end of each cast, drops on the water will be too hard causing suspicion on the fish. Or it might fold reducing the power to turn it over and drop the fish onto the surface. 

The best leader should be long and will aid to good casting. If one section is heavy, for instance in the butt section, then a long leader will be easy to cast and allow the angler to set the fly down quietly and accurately. 

How to build a fly fishing leader?

The first thing to do when building a fly fishing leader is to select the best materials. Some of the best materials to use include; braided nylon, monofilament nylon, and the latest fluorocarbon material. The fluorocarbon is claimed to be invisible in water. This is beneficial when it comes to fly fishing. The only disadvantage of this material is that it is slightly heavier for a standard size. 

Steps to get started 

The first step is to take the leader material and runoff 9ft. Cut the material into two equal halves and tie two blood knots. Leave about 9 inches from one end. Wet the knots when tightening to ensure that the material stays strong. Have a dropper sitting at the mainline and trim the tag end that is near the knot. 
The other way is to take two materials 8-9ft and the other one about 12 inches. Make a knot where water would turn with two materials around the middle. Ensure that you moisten the knot section and trim the tag end. Ensure that you trim the lower tag and this will help to make the dropper sit perpendicular. Trimming the upper tag will help to make it sit near the main line. 

The last thing to do is to form a loop. This will be formed at the end of the leader. In order to join the fly line and the leader, you only need to form a loop to loop connection ensuring that everything is laid properly before tightening down.


Prev: How Long Should A Leader Be For Fly Fishing?

Next: The top features of Cortland fly fishing rod

Tags: Fly Fishing Leaders


Tracking Orders